NOTE - The power cannot be turned off while the machine is sending
or receiving a fax, or when the received fax or the unsent faxes are stored in
the machine's memory. Make sure the machine completed sending or receiving
all faxes before disconnecting the power cord. If you unplug the power cord,
all the faxes stored in the machine's memory are deleted.
1.
If you press the [Stop]
button during scanning the document will stay where it is in the ADF and a
message will appear on the LCD. Press the [OK] button and the machine
will feed the document out of the ADF.
2.
If the original gets jammed in the
ADF press the [Stop] button to cancel printing.
Remove any pages other than the jammed page from
the ADF, and then open the document feeder
cover.
5. Pull
out the jammed document from the ADF.
1.
Close the document feeder cover and
then turn on the machine.
2. If the document is jammed in the document output
slot, close the document tray as shown in the figure below and pull out the
document.
1.
Note - The document may not feed properly depending on the media
type, or your environment, such as when the temperature and humidity are either
too high or too low. In this case, reduce the number of document pages to
approximately half of the loading capacity. If the document still jams, use the
platen glass instead.
When rescanning the document after clearing the error, rescan it from the first
page.
Resolution
1.
Press the [OK] button to
resolve the error and then try again after loading the documents.
Or
